Nippondenso 10P-Series Shaft Seal Kit SK-740N
Shaft seal kit for 10P-series Denso compressors including:
This is the early version that has the extractor lip on the steel seat. This version is for compressors where the seal can be removed without taking the compressor apart. It is easily identified by looking into the nose of the compressor once the clutch is removed. If there is a snap ring visible, this is the correct seal. If you are not sure, purchase Part# SK-753G as it will fit both types.
**LARGE O-RING USED FOR FRONT NOSE HOUSING SHOWN IN PIC HAS BEEN DISCONTINUED AND IS NO LONGER INCLUDED IN THE KIT**.
Disclaimer: All Seal kits on this site are to replace original equipment seals. May not fit in aftermarket compressors or previously rebuilt compressors.